Oliver 880 power booster9/5/2023 ![]() I was running my 1600 gas tonight and when I shut it off the amp light stayed on dim I thought this wasn't good so I disconected the battery there was some smoke coming from the generator an it was hot I put a new voltage regulator on last year when I rewired the tractor all has been fine since about 100hrs any suggestions would be appreciated You can get all of these things from Korves Oliver 61. Posted on Apat 08:35:18 PM by Larry Harsin Is the rear-facing combination light and tail light still available? How about a toolbox lid for the left foot rest? Does anyone have a set of brackets, or brackets with lamps? I want it to be as close to original as possible. My Super 55 is missing the light housings/wiring for all head & tail lamps. Posted on Apat 00:27:08 AM by Patrick Flohe Use your own judgement, but if you have to, take the chain off and see how it looks. Posted on Apat 06:31:46 PM by Larry Harsin I guess I'm just not looking right, should I pull the chain for the best view of sprocket alignment? Or checking w/the chain on ok? You can put a jack bolt in to help raise the hydraul, if it is sagging. The best way is by visually observing what is happening. Posted on Apat 05:43:03 AM by Larry Harsin The O/U sprocket has some play could that be the cause? What's the best way to see if the sprockets are lined up properly? Thanks Worst vibration is in over, or when at road speeds (starts when a load is applied, small hill, etc). Changed the coupling chain but didn't seem to make much difference. My 1755 diesel has a vibration in the drive line, been slowly getting worse over the past few years. Posted on Apat 05:44:14 AM by Larry Harsin Larryĭo you know were I can buy the grommet on the hood for the gas filler for a 1800 If the tractor is decent and runs good, that is a bargin and under market price in my area. Posted on Apat 10:05:30 PM by Larry Harsin LEVERS ARE BROKEN AND WAS WONDERING IF THIS IS A HARD FIX AND ARE PARTS AVAILABLE? IS 1200 TOO MUCH TO ASK FOR THIS TRACTOR? I HAVE A SUPER 88 TRACTOR FOR SALE AND BOTH HYD. Posted on Apat 10:08:01 PM by Larry Harsin torque, also what rocker arm clearance is. I'm looking for head bolt, main and rod brg. I have a 1650 D 283 wakashaw that I'm putting a used block in. Undersize bearings are available for this crank. ![]() Your machinist at your local automotive shop will be able to analyze what has to be done. You'll have to pull the crank out and have it inspected. Posted on Apat 09:18:35 PM by Larry Harsin is there any way i can have it reground and put in oversized bearings or is it junk. My 1955 spun a rod on the number 3 cylinder. Posted on Apat 10:32:06 AM by austin white "Ask The Oliver Mechanic" Archives "Ask The Oliver Mechanic" - April, 2010 Archives
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |